Vensory Micro-Infusion Kit™ — How to Use

At-home texture refinement made simple, safe, and effective.

⚠️ Before You Start (Safety & Skin Prep)

Do NOT use the Vensory Micro-Infusion Kit™ if:

  • You have active acne, open wounds, cold sores, dermatitis, eczema flare-ups, rosacea flare, or any infection on the treatment area
  • You are pregnant or nursing (consult your doctor first), currently on isotretinoin/Accutane (wait 6+ months after stopping), or being treated for a serious skin condition (unless approved by your dermatologist)
  • You've had a laser treatment, chemical peel, microdermabrasion, or strong in-clinic exfoliation on that area within the last 7–14 days
  • You have raised moles, a history of keloid scarring, or abnormal wound healing
  • You are treating areas where the skin is extremely thin or compromised
💡 Patch Test (Recommended)

24–48 hours before your first session, apply a small amount of Vensory serum (hyaluronic acid + peptides) along your jawline or behind your ear.

If strong burning, rash, or swelling occurs → do not use the kit.

1

🧼 Prep Your Skin & Workspace

Tie your hair back so your face and neck are fully visible.

Wash your hands thoroughly with soap and water.

Double-cleanse your face and neck:

  • First cleanse: remove makeup, sunscreen, oils.
  • Second cleanse: ensure no residue remains.

Once clean, avoid touching phones, counters, bottles, etc. to prevent contamination.

Clean skin = smoother treatment + lower irritation risk.

2

🧪 Open the Vensory Serum Vial

Each 5 ml vial is sealed for freshness and sterility.

  • Hold the vial firmly.
  • Locate the arrow on the metal cap and peel upward from that side.
  • Lift and peel the metal seal completely off.
  • Remove the rubber stopper to expose the serum.

If any part of the seal doesn't come off cleanly, simply peel gently until removed. Do not use scissors or sharp tools.

3

💧 Fill the Device & Attach the Needle Head

First-time users: Your device comes with a needle head already attached. Simply fill the chamber with serum (as described below) and proceed to Step 4.

Replacing a used head: If you're attaching a new needle head for a future session, follow both the "Fill the chamber" and "Attach the needle head" instructions below.

Fill the chamber:

Pour the entire vial of serum into the clear reservoir of your Vensory device.

Attach the needle head (if replacing):

  • Screw on a new sterile single-use needle head.
  • Twist until it feels snug and secure — do not force or overtighten.

Never reuse a needle head or share your device with others. A fresh sterile head for every session ensures safety and optimal results.

4

🔁 Prime the Device

  • Turn the device upside down and let it sit for ~2 minutes.
  • While still upside down, gently press the center of the needle head on a clean, hard surface.
  • Continue lightly pressing until you see tiny air bubbles rising into the reservoir — this means the serum has filled the internal channels.

If it takes longer than expected, keep gently pumping until primed. Do not loosen the needle head to adjust airflow.

5

✨ The Micro-Infusion Treatment (Face & Neck)

Recommended routine: every 1–2 weeks, preferably at night.
Total treatment time: ~10 minutes

5A. General Technique
  • Work in sections: forehead → cheeks → nose → chin → neck
  • Hold the device perpendicular to your skin
  • Use light, quick tapping motions, not forceful jabs
  • Sensation should feel like a mild prickling
  • Use 50% overlap — each new stamp should cover half new/half previous area
  • For stubborn texture areas, you may do 2–3 light passes if your skin tolerates it

Stop if:

  • You feel sharp pain
  • Your skin becomes intensely red immediately
  • You see pinpoint bleeding (not expected with cosmetic depth)
5B. Area-By-Area Guide

Forehead:
Start in the center, move outward toward temples. Avoid stamping into the hairline or too close to eyebrows.

Cheeks:
Stamp outward from nose toward ears. Spend more time on textured or pore-visible areas.

Nose / T-Zone:
Use small, controlled motions along the bridge and sides. Great for pore refinement — but keep pressure light.

Chin & Jawline:
Stamp along the jaw and under-chin area using consistent overlap.

Neck (Optional):
Move in upward stamping motions. Avoid the central throat hollow if uncomfortable.

Eye Area (Optional / With Caution):
Only treat along the orbital bone. Use very gentle pressure. Never stamp directly on eyelids or too close to the lower lash line. Only 1 light pass — everyone's sensitivity differs.

Avoid stamping over: Active acne, open cuts or scratches, cold sores, raised moles, irritated or inflamed patches.

6

🧴 Use Any Leftover Serum

After stamping:

  • Unscrew the device.
  • Pour remaining serum into your clean palm.
  • Gently press it over your face and neck.

Do not store leftover serum — discard anything unused after your session.

7

🚿 Immediate Post-Treatment Care (First 24 Hours)

Your skin is more permeable and sensitive right after treatment.

For the next 24 hours:

  • Do NOT wash your face again
  • No makeup (if absolutely necessary, use sensitive-skin formulas only)
  • Avoid direct sun exposure (use a gentle SPF if outdoors)
  • Avoid heavy sweating (gym, running, hot yoga)
  • Avoid hot showers, steam rooms, saunas
  • Avoid pools, hot tubs, and chlorinated water
  • Do not touch your face with unclean hands
8

🌱 Next 2–3 Days

In the morning:

  • Cleanse gently with a non-foaming, non-exfoliating cleanser
  • Apply a hydrating, fragrance-free moisturizer

Avoid for 48–72 hours:

  • Retinol / retinoids
  • AHAs, BHAs, PHAs
  • Vitamin C (L-ascorbic acid)
  • Exfoliating cleansers (e.g., salicylic acid wash)
  • Scrubs or any exfoliating tools

Resume normal routine gradually once your skin feels calm.

If you experience severe burning, swelling, or irritation → stop using and consult a professional.

9

🧽 Clean & Store Your Vensory Device

  • Remove and discard the used needle head immediately
  • Rinse the empty reservoir with lukewarm water and a gentle cleanser
  • Place the device on a clean surface and allow it to air-dry completely
  • Store the cleaned device body in its box or a clean container — you'll use it again with a new replacement needle head for your next session
  • Keep out of reach of children
10

🕒 How Often to Repeat

Most users see great results with a treatment every 1–2 weeks. Each treatment requires a fresh needle head.

Texture-focused routines often follow:

  • 6–12 sessions across a few months
  • Then switch to a maintenance schedule (less frequent)

Consistency matters more than intensity.